Home > Power Distribution Furman PS-PRO E II
Furman PS-PRO E II, Power Distribution
Item number: 100029856
This item is not part of our current product range.
Power Distribution •
- Power conditioner and sequencer • 16 A available current • 3 delay time offsets for each of 2 outputs through the locable central switch on the front panel, alternatively controlled remotely[ *] Shutdown in reverse order • 8 x rear panel and 1 x front panel connectors IEC-320-230 V • SMP Series Mode Protection maintenance-free surge protection, transient over-voltages and are within <1 nanosecond captured, absorbed and dissipated • LiFT Linear Filtering Technology mass-free circuit noise (10 dB @ 10 kHz, 40 dB @ 100 kHz, 100 dB @ 10 MHz) • Rear panel BNC connector for gooseneck lamp (12 V, 0.5 A), switchable from the front panel • 19 "/1U, depth 27 cm • Weight 5 kg • The Furman PS-PRO Series II AC Power Conditioner/Sequencer provides advanced and comprehensive transient voltage surge suppression technologies. In addition to the Series Multi-Stage Protection SMP circuit this A/C Power Sequencer also features Furmans exclusive Linear Filter Technology LiFT. Furmans maintenance-free SMP surge suppression eliminates service calls. Traditional surge suppression circuits sacrifice themselves when exposed to multiple transient voltage spikes, requiring the dismantling of your system, and repair of your surge suppressor. With Furmans SMP, however, damaging transient voltages are safely absorbed, clamped and dissipated. No sacrificed parts, no service calls, no down time. Unlike some series mode suppressors, Furmans maintenance free feature is not at the expense of potential equipment failure! While other designs offer clamping voltages that are well above 300Vpk, Furmans SMP clamps at 188Vpk, 133 VAC RMS even when tested with multiple 6000Vpk - 3000 amp surges! Furmans trusted over-voltage circuitry protects against all too frequent open neutral wiring, or accidental connections to 208 or 240 VAC. Furmans SMP with over voltage protection immediately shuts off the incoming power until the over voltage condition is corrected. The PL-PRO II features LED rack lights which produce virtually no heat and provide an extremely long life. A dimmer control for the rack lights allows the user to adjust the level of illumination or simply switch the lights off. All units include a rear mounted BNC jack which accepts any standard (12VAC, 0.5A) gooseneck lamp for rear rack illumination, as well as a front panel switch which controls the goosenecks operation. A front panel mounted master power switch is protected by a hinged cover, preventing accidental disconnection of AC power to the units outlets. The front-panel circuit breaker - power switch can be quickly and easily reset should the unit be overloaded. Also feature a 10 foot, 12 gauge heavy-duty power cable.