Home > Power Distribution Furman PS-8RE Series II
Furman PS-8RE Series II, Power Distribution
Item number: 2820028
This item is not part of our current product range.
Power Distribution • 10-amp Power Conditioner/Sequencer with 3-stage Power-on, Series Multi-stage Protection, and Linear Filtering • Power conditioner and sequencer • 10 A • 3 delay time offsets for each of 2 outputs by the central button on the front, alternatively controlled remotely • Reverse order at shutdown • 8 x rear panel and 1 x front panel connectors to IEC-320-230 V • SMP Series Mode Protection maintenance-free surge protection, transient over-voltages and are within <1 nanosecond captured, absorbed and dissipated • LiFT Linear Filtering Technology ground-free circuit noise (10 dB @ 10 kHz, 40 dB @ 100 kHz, 100 dB @ 10 MHz) • Rear panel BNC connector for gooseneck lamp 12 V 0.5 A, switchable from the front panel • 19 "/ 1U, depth 27 cm • Weight 5 kg • The Furman PS-8R II power conditioner and sequencer features Furman's SMP+ technology, Linear Filter Technology LiFT with Extreme Voltage Shutdown EVS and a high-current TVZ-MOV. Together, these technologies comprise what is the world's most advanced and comprehensive transient voltage surge suppressor. The Furman PS-8R II power conditioner / sequencer helps avoid speaker thumps and gear-damaging power-on spikes. Six sequenced rear-panel outlets in 3 groups, two switched rear panel outlets, and one-front panel switched outlet give you plenty of plug-in options. The PS-8R II uses Furman's SMP+ surge suppression that virtually eliminates service calls. Traditional surge suppression circuits are designed to sacrifice themselves when exposed to multiple transient voltage spikes, requiring the dismantling of your system, and repair of your surge suppressor. With the PS-8R II and Furman's SMP+ transient voltages are safely absorbed, clamped and dissipated. No sacrificed parts, no service calls, no down time. While other power distribution designs clamp voltages that are well above 300 volts peak, Furman's SMP+ clamps at 188 volts peak, 133 volts AC RMS even when tested with multiple 6000volts peak/3000 amp surges. The PS-8R II features Furman's over-voltage circuitry that protects against accidental connections to 208 or 240 volts AC, by shutting off the incoming power until the over voltage condition is corrected. The PS-8R II Power Conditioner / Sequencer is capable of powering up a rack full of equipment in a 3-step delayed sequence. The sequence is reversed for power-down. The sequence can be initiated with either momentary or maintained switches, locally or remotely.